Real product photography
200 Series Tailgate Short Cable Stay (Pair).
Replacement tailgate cable stays that sit 10mm shorter than factory, so your 200 Series rear drop tailgate stops clear of the bar. Sold as a pair — a straight swap, no cutting or drilling.
Tailgate stops clear.
No more resting on the bar.
With a rear bar fitted, the factory tailgate drops too far and rests on the bar. These stays are 10mm shorter, so the tailgate stops a touch higher and clears it.
10mm shorter
Lifts the tailgate's resting point just enough to clear the bar.
Direct swap
Pulls straight in for the factory cable stays — no cutting, no drilling.
Sold as a pair
Two stays in the pack, one for each side.
A few minutes a side.
~5 MIN · 1 PERSON · SPANNER
Remove the factory stay
Undo the factory cable stay at both ends and take it off.
Fit the short stay
Bolt the Novaa short stay in its place at both ends.
Do the other side
Repeat on the second side and check the tailgate clears the bar.
The numbers, all in one spot.
Confirmed against the product master spec. If a figure you need isn't here, send us a message — we won't guess.
Cable stay
- Type
- Replacement tailgate cable stay
- Length
- 10 mm shorter than factory
- Sold as
- Pair (one per side)
- Fitment
- Toyota LandCruiser 200 Series — all models
Build
- Install
- ~5 min, no cutting or drilling
- Design
- Designed & tested in Australia
Common questions.
Will it fit my 200 Series?
Yes — it's a direct replacement for the factory tailgate cable stays across all 200 Series model years.
Do I get one or two?
Two — they're sold as a pair, one for each side.
How much shorter are they?
10 mm shorter than the factory stays, which lifts the tailgate just enough to clear a rear bar.
